--------------- Original Message --------------- From: Technical Solutions - SEA [web-implementation-support-sea-tel@google.com] Sent: 9/13/2022 10:20 AM To: mpsinsulationpins@gmail.com Subject: 谷歌广告 转化代码 (增強型) [ ]



Nylon rods are processing?

by:MPS     2020-10-05

nylon rods widely used, is a plastic instead of steel, iron, copper and other metal material, is an important engineering plastics; Cast nylon instead of mechanical equipment wear parts, instead of the copper and alloys for equipment wear resistance. Nylon rods is suitable for making wear parts, transmission parts, home appliance parts, automotive parts, wire rod to prevent the machine parts, chemical machinery parts, chemical equipment. Manufacturers in the production of nylon rods nylon rods so what are the process?

1, the processing is less than 30 mm holes, because the holes in the space is narrow, heat dissipation is difficult, operate lathe lathe speed must be reduced to less than 300 r/min, use cutting fluid for cooling; At a constant speed slow, into the drill, chip removal in time; Through the hole to the bottom of the hole, the bit to go through, need more care, reducing the drilling speed, cutting fluid or cooling water, must be evenly spray to the orifice position.

2, processing more than 30 mm punch, drill grinding sharp in the first place, easy to machining, reduce scrap rate; Under the lathe speed reduced to 180 r/min, greater than 55 mm hole, lathe speed can be reduced to about 60 r/min; At a constant speed slow, into the drill, timely clearance, spray adequate cutting fluid; Drill a hole, be careful, reducing the drilling speed.

3, small hole reaming processing, lathe speed should be lower than 60 r/min. Uniform, low speed into the drill, the operator must hold the tailstock lever, prevent bit rapidly into the hole in the lathe, cause products split; Cutting fluid spray evenly.

4, external processing, processing cutting tool choice white steel knife, unfavorable choose alloy cutting tools, cutting tools should maintain sharp; Lathe speed is not lower than 200 r/min; Proper feeding speed, improve the machining accuracy and surface finish.

about processing technology is introduced to the nylon rods, nylon rods, insulation nails, if you have about the demand of the geothermal staple, but manufacturers contact with me by telephone.

this website: https://www. 国会议员, insulationpins。 com/news/459。 HTML keywords: nylon rods, nylon rods manufacturers
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...