Sub-station

MPS

Introduced the processing technology of the nylon rods nylon rods manufacturer

by:MPS     2020-10-07

today for you to introduce the processing technology of the nylon rods, want to know friends followed the introduction of factory have a look at it.

1, the processing is less than 30 mm holes, because the holes in the space is narrow, heat dissipation is difficult, operate lathe lathe speed must be reduced to less than 300 r/min, use cutting fluid for cooling; At a constant speed slow, into the drill, chip removal in time; Through the hole to the bottom of the hole, the bit to go through, need more care, reducing the drilling speed, cutting fluid or cooling water, must be evenly spray to the orifice position.

2, processing more than 30 mm punch, drill grinding sharp in the first place, easy to machining, reduce scrap rate; Under the lathe speed reduced to 180 r/min, greater than 55 mm hole, lathe speed can be reduced to about 60 r/min; At a constant speed slow, into the drill, timely clearance, spray adequate cutting fluid; Drill a hole, be careful, reducing the drilling speed.

3, small hole reaming processing, lathe speed should be lower than 60 r/min. Uniform, low speed into the drill, the operator must hold the tailstock lever, prevent bit rapidly into the hole in the lathe, cause products split; Cutting fluid spray evenly.

4, external processing, processing cutting tool choice white steel knife, unfavorable choose alloy cutting tools, cutting tools should maintain sharp; Lathe speed is not lower than 200 r/min; Proper feeding speed, improve the machining accuracy and surface finish.

nylon rods is a kind of important engineering plastics, can replace mechanical equipment wear parts, instead of the copper and alloys for equipment wear resistance. Has good toughness and wear resistance force, oil resistant, seismic, stretching, bending strength, and has the characteristics of small water absorption, good dimensional stability, and is used for processing various wear-resistant high strength parts. Is suitable for making wear parts, transmission parts, home appliance parts, automotive parts, wire rod textile machinery parts, chemical machinery parts, chemical equipment. Such as turbine, gear, bearing, impeller, shaft, dashboard, drive shaft, valve, blades, wire rod, high pressure washers, screws, nuts, seals, shuttle, Jane, bushing connector, etc.

nylon rods main features:

mechanical strength, stiffness, hardness, high toughness, good ageing resistance, good mechanical damping capacity, good sliding resistance, excellent wear resistance, good machining performance, when used for precision control, no creep phenomenon, anti-wear performance good, good dimensional stability.

hope the above on the processing technology of the nylon rods to bring us some help.

this website: https://www. 国会议员, insulationpins。 com/news/436。 The machining technics HTML keywords: nylon rods, nylon rods, nylon rods
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...