Sub-station

MPS

Floor heating staple production agnail mechanics Angle design is reasonable

by:MPS     2020-10-14

fixed way mainly USES the card pin to floor heating pipe is fixed, the use of staple of floor heating to make the floor heating pipe fixed more rapid and convenient. Steel stud card are U design, u-shaped opening distance according to the diameter of the floor heating pipe to determine, is commonly 3. 5 - 4. 0 cm, slightly bigger than the staple of semicircle diameter, this design is mainly use the elasticity of the nail wire card itself, make card pin has a stretch of outward.

staple of floor heating is the basic standard

specification: mainly phi is 16. 20 and phi phi (25 Cardin arc diameter) Give priority to.

control the total length of 100 - card pin Between 125 mm.

appearance: look from the exterior, there can be no flash, burr, sag in place to ensure that the user feel comfortable and easy to take hold. In addition, the tip should be more sharp, peg leg deformation; 。 Fixed:

enter the thermal insulation layer agnail can quickly open, resistant to pull off force should not be less than 15 Newton; 。

penetration: thermal insulation layer can easily penetrate 20 kg/m3; 。

staple of floor heating technology requirements:

1. Staple of floor heating is higher hardness, better toughness.

2。 The card is better nail of low temperature resistance, agnail mechanics Angle design is reasonable.

3。 Floor heating card pin should be able to adapt to different ways of operation.

this website: https://www. 国会议员, insulationpins。 com/news/515。 HTML keywords: warm card nails, nail warm card production
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...